School Bus Fleet Magazine Forums
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Professional Garage
 Enter Forum: Professional Garage
 ABS issue need some help		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

valleybusman
Top Member

USA
815 Posts
Posted - 03/13/2024 :  10:13:56 AM  Show Profile  Send valleybusman an AOL message  Reply with Quote
I have a 2021 Bluebird vision. Have a ABS light on. My reader says its drive axle right release solenoid shorted. Is this the sensor up against the ring in the brake drum? I have only done a handful of sensors and they were in the brake spider. Is this the same issue? Thanks The code is 651-20

tigger2
Advanced Member

USA
470 Posts
Posted - 03/14/2024 :  04:30:23 AM  Show Profile  Click to see tigger2's MSN Messenger address  Reply with Quote
Follow the right service brake hose to the valve, it should have wires going in and out. check wiring for rubs and shorts open connector and check valve for internal short.
Go to Top of Page

valleybusman
Top Member

USA
815 Posts
Posted - 03/14/2024 :  06:00:31 AM  Show Profile  Send valleybusman an AOL message  Reply with Quote
Tigger you are talking the wiring coming off the modulator to the sensor?
Go to Top of Page

Bluenozer
Top Member

Canada
701 Posts
Posted - 03/14/2024 :  06:51:03 AM  Show Profile  Reply with Quote
Don't think he is
if one of those wires were bad you would have a code for that wheel end sensor if you have jpro you would have the trouble shooting for Bendix brake systems , jpro comes with acom diagnostics if it was installed correctly on your laptop
OEM trained in wiring and all engine platforms for over 20 years
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
 


School Bus Fleet Magazine Forums © 2022 School Bus Fleet Magazine Go To Top Of Page
This page was generated in 0.62 seconds. Snitz Forums 2000