Help, I have a 2005 bluebird vision. The bus will run half way through its run and then the check trans light will come on and no power, so i tell him to shut it off. I take a bus to him and when i start back to the shop it runs fine. the next day samething, Could this be the J1939 harness? Thank for any info.......... Dan
I had a c2 do that and it turned out to be the turbine sensor in the Allison 2500 series transmission. It would loose all power(as in it would not go foward at all) then after it cooled off a little it would do fine again.
If your has a pushbutton trans you can pull the codes at the trans control panel, if not you have to pull it with a scanner
check trans light
Posted - 01/04/2011 : 3:42:48 PM
